about redwood redwood decks redwood fences redwood builders redwood forests redwood reference library
 

Cut the 2x4 cleats to 27 inches and trim the ends at 45 degree angles starting 2 inches down from top edge. Place a cleat on edge 7 inches from each end of the table top. Allow a 3/4-inch margin from the table's edges. With the combination countersink bit, drill two screw holes into the cleat above each slat, deep enough to set the screw heads below the surface. Fasten to slats with 4-inch screws. 

 

 

 


Assemble the legs

     
CALIFORNIA REDWOOD ASSOCIATION · 1 888-CALREDWOOD · info@calredwood.org
© 2005, California Redwood Association. All rights reserved.